Note: In computer B), no Authentication tab is available for the network settings, and I can thus not unclick "Enable IEEE 802.1x authentication for this network". Wireless connection dropped about every 5 minutes (always seems to fail when I try to copy some large AVI files).ġ) Tried to unclick "Enable IEEE 802.1x authentication for this network" in computer A). Advanced configuration of the Router is available through the provided browser-based utility.
Linksys ae3000 setup software software#
You have to click on your network then click on authentication in the tabs and it will be there, just unclick it and presto!Ī) Have one XP Prof connected via cable to WRT54G (firmware v3.03.1).ī) Have one XP Home edition connected to WRT54G via wireless (WUSB54G).ĭistance between Router and wireless computer is less than 5 meters (no walls, signal good)Ĭ) WRT54G Configured with 64bit WEP, most other settings in "default mode"ĭ) Running Norton Internet Security in both computers (tried to switch it off, but same 'status'). Setup and use of the Router is easy using Cisco Connect, the software that is installed when you run the included CD. All you have to do is unclick "Enable IEEE 802.1x authentication for this network". I've had the wireless adapter for 6 months, and it has worked fine up until a few weeks ago. I've got Spybot, Spyware Blaster, and McAfee's 2005 security program running as well as Norton Anti-virus 2005. But I don't think I should have to be going through all of these steps everytime I turn on my computer. When I do re-establish the connection, I click on 'repair', and this also seems to fix the problem. This works, but a few minutes later, the connection is lost again. So I click on the little computer icon, open up the wireless options, and then click on the name of the network to re-establish the connection. Connect your USB-equipped desktop or notebook computer to a wireless network at incredible speeds, incorporating two new, blazing fast technologies USB 2.0. I get a pop-up balloon that says "wireless connection unavailable".
I am not losing my internet connection, just my connection to the router. For the past several weeks, my external Linksys adapter has been losing its connection to the router (which is upstairs) a few minutes after I get online.